I did not get much work done on the boat during the week (nor did I last weekend or the days during the week before so it has been 2 weeks with not much done). I did manage to sand the inside of the roof to smooth off
I did not do any work on the boat this weekend due to the mini boat show at Darling Harbor over the weekend and my small participation. I was invited by Dave at Drive Marine to share some of his stand for the show to
The usual early start today, I got in and finished the roof inside glassing. I moved the frames to reveal the unglassed sections below them. I also found quite a large (about 200mm round) patch of glass that had not
Today was open day at the shed, I had in total 8 visitors at various times during the day. I met a prospective Schionning builder and his wife and father, as well as Jo’s mum and friends as well as a couple of my
Now that the roof is out and turned over I need to glass the inside. Before that is done the roof is still flexible so it needs the glass to fix its shape and stiffen it. I carefully sanded the glue that had squeezed
The boys moved 9 Lives today. They hired 4 piano trolleys, jacked the boat up and placed the 4 trolleys in place and pushed the boat over. Easy. When the time comes (soon) to move the boat out they will employ the same
I started early as I usually do on Sundays so I could knock off early. Some kind of water-ski races are being held in Gosford this weekend (national titles?) and Jo wants to watch them a while. And after about an hour
The roof has been released from the mold but I am yet to turn it over. It took me over an hour to release the roof. Many of the screws just refused to come out, a combination of resin in the heads (or under glass) or
I called into the shed this morning for an hour to add that section of glass I mentioned yesterday. The idea to add it only occurred to me last night when looking at the photos. I realised I would have a hollow about
Yesterday I sanded down the starboard side glued strip planks smooth ready for glassing. I had a similar bump where the hard turn problem with the wider planks meets the thin strip planks, as I had on the port side. I